Creality Handle Tripod for CR-Scan Otter/Raptor/Sermoon S1 3D Scanner | 2-in-1 Extension Pole with 1/4" Thread, Handheld Grip and Fixed Stand, Aluminum & ABS, Non-Slip Rubber Feet

by Creality
Availability: In Stock
Price: $19.98 $24.99
You save: $5.01 (20%)
* Price as of 00:09 CET - Details
Share This Page

Product Features

  • TWO TOOLS IN ONE GRIP - HANDHELD MODE AND FIXED-STAND MODE: Flip between handheld scanning, where the grip steadies the scanner and cuts tracking loss on long passes, and fixed-position scanning, where the tripod locks the scanner at a set height and angle. Fixed mode keeps the scanner motionless for repeat scans of the same part, which is what makes captures comparable between sessions
  • BUILT FOR OTTER, RAPTOR AND SERMOON S1 - AND ANY 1/4-INCH DEVICE: Developed as the official grip stand for the Creality CR-Scan Otter, Raptor and Sermoon S1. The mount is a standard 1/4-inch-20 camera thread, so it also holds webcams, action cameras, compact DSLRs and phone clamps - one stand, several jobs. Not for the Ferret series: those scanners use a different mounting interface.
  • 93 GRAMS IN THE HAND, 11 POUNDS ON THE STEM: The body is aluminum and ABS, so the stand weighs only 93 g (0.2 lb) yet is rated to hold up to 11 lb. Your Raptor weighs about 0.82 lb - roughly a thirteenth of the rating - so the stand stays rock-steady with headroom to spare. Soft rubber on the grip and on all three feet keeps it non-slip on desktops, benches and job-site tables
  • FOLDS SMALL, EXTENDS TO WORKING HEIGHT, PACKS ANYWHERE: The pole retracts down to about 5.1 in (13 cm) and locks at about 7.1 in (18 cm) with one press, then drops into the scanner bag, a backpack pocket or a jacket pocket. At 93 g you will forget it is packed - which is the point, because the stand only helps if it is actually with you on scanning day.
  • SETUP IN UNDER A MINUTE - KNOW ABOUT THE PLASTIC COVER FIRST: The Otter/Raptor/Sermoon S1 body has a small plastic-covered opening for the mount; snap it open (it matches the body color, so look closely), seat the stand on the 1/4-inch thread and tighten. Adjust the angle, lock it, and the scanner stays fixed. Scanner not included.

Product Details

BrandCreality
SKUB0H8YTKDWT
ModelCR-Tripod
MPNAMUS-CU-SCAN-TRIPOD

More 3D Scanners